Paper Mache Hot Glue Gun Tree / Holster

Hot Glue Gun Tree / Holster
Submitted by Beth Lyons

Beth Lyons' Hot Glue Gun Holster

Beth Lyons' Hot Glue Gun Holster

Estimated Cost to Make the Item: 25 cents

My glue gun (which I adore!) came with a little (useless) wire thing that I was supposed to be able to use to prop it up while it was heating up or while I was using it. But it didn’t work at all for me.

I needed something that I could place the gun in while it was heating up (preferably something that could catch the drips of glue) and would be relatively easy to replace the gun in when I was using it.

Again, I found making my own thing easier than trying to buy one.

And again, I had all the supplies:

1 empty toilet paper core (free)
1 3″ x 9″ piece of corrugated cardboard (or longer) (free)
1 glue stick
jonni clay for decoration / stability

It might be easier to cut the cardboard core before gluing it to the cardboard, but that’s not what I did. I hot glued the tp core to the cardboard strip, then cut a 3 1/2 in slice out of the back to accommodate the hand-grip and power cord of the glue gun. I then cut a 1″ slice from the front to accommodate the trigger. Both slices were about 1/4 wide.

I didn’t measure these when I was doing it. Just eyeballed it and then adjusted as needed.

I then covered the front end of the cardboard with a strip of aluminum foil so I can peel off the glue when it builds up.

It keeps the glue gun ready but out of my way and out of danger of burning anything (from laying on a table).

Again, not necessarily pretty (tho I did push a bark pattern in the jonni clay) but very functional.


– To see all of our reader-submitted Practical Paper Mache projects, click here.

 

1 Comment

Leave a Comment

Heads up! You are attempting to upload an invalid image. If saved, this image will not display with your comment.

Heads up! You are attempting to upload a file that's too large. Please try a smaller file smaller than 250KB.

Note that images greater than 250KB will not be uploaded.

Tweet
Share
Pin
+1